Aquabot Ultrabot Magnum

Equipped with detectors in the form of infrared sensors attached to the body of the cleaner and angle detectors integrated to the motor avoid the unit becoming stuck or blocked at the foot of the pool wall whatever the pools configuration may be.

High-density, foam PVA brushes allow the Magnum to be used on any pool finish (liner, tiles, concrete, PVC, etc).

The Aquabot Magnum gives the possibility of using a delay start of 2 hours.

Pool cleaner with protection system

Switching on your pool cleaner out of water will put security mode into action, including the pump and low current transformer... If you switch on the low current transformer without the pool cleaner, the security mode will activate after 10 to 15 seconds.

For pools featuring an immersed border (or a Californian border), the pool cleaner inverses its movement as soon as it emerges when reaching the waters edge. In the case that the unit does not return into the water, it automatically goes to security mode, (including its low current transformer).

If the cleaner meets an obstacle in its path (ladder, lamp, discharge nozzle, pool cover or any other horizontal or vertical object) the cleaner is programmed to move around the obstacle in question and continue its cycle.

If an obstacle becomes stuck between the body of the unit and it's brush (towel, cable...), the unit will try to distance the object in question to continue its cycle. If this fails, the pool cleaner (including its low current transformer) will adopt security mode automatically.

If the pool cleaner turns over and cannot continue its movements, the pump will operate for 5 seconds. The drive system will forward/reverse and then go to security mode.

Intelligent pool type detection system

The Aquabot VIVA uses a microprocessor programmed with an algorithm studied to protect and optimise its use.

From the moment it is switched on, the cleaner will detect the surfaces and waterline, defining the profile of the pool it will clean. The intelligent algorithm will optimise the cleaners movements and trajectory throughout its cycle.

The unit will determine the type of finish in the pool (liner, ceramic, concrete) adapting the working rhythm of the pump, preserving its lifespan.

If the unit comes across a difficult spot (grease, smooth patch on liner...) during its cycle, it will accelerate and move along quickly through the difficult zone.

The unit gauges automatically its duration of cycle and time spent on waterline in comparison to the walls and bottom surface, optimising time spent.

The algorithm corrects and balances the rotations of the cleaner clockwise and anti-clockwise, avoiding a tangled cable.

Technical features

See all theAquabot range

Warranty

2 years